MCQs on Fits & Hot and Cold Working of Metals

1 - Question

Which of the following is not a classification of fit?


a) Clearance
b) Transition
c) Interference
d) Enjoining

View Answer

Answer: d
Explanation: Simple classification of fits is down in 3 categories.




2 - Question

Which of the following always provides a positive clearance between the hole and the shaft over the entire range of tolerances?


a) Clearance
b) Transition
c) Interference
d) None of the mentioned

View Answer

Answer: a
Explanation: Clearance positive imparts a positive clearance.




3 - Question

In this case, tolerance zone of hole is entirely below that of the shaft.


a) Clearance
b) Interference
c) Enjoining
d) Non of the mentioned

View Answer

Answer: b
Explanation: Interference fit provides a positive clearance and hence tolerance zone of hole is below that of shaft.




4 - Question

Which of the following are true for system of tolerances to the shaft and the hole?


a) In hole-basis system, various shafts are associated with a single hole
b) In hole-basis system as well as shaft-basis system, various shafts are associated with multiple holes
c) In shaft-basis system, various shafts are associated with a single hole
d) None of the mentioned

View Answer

Answer: a
Explanation: As per the standards.




5 - Question

The description of tolerances consists of two parts namely?


a) Fundamental deviation and magnitude of tolerance
b) Magnitude of deviation and magnitude of tolerance
c) Mean deviation and magnitude of tolerance
d) Fundamental deviation and tolerance

View Answer

Answer: a
Explanation: Fundamental deviation and magnitude of tolerance are decrypted in the tolerance.




6 - Question

Which of the following are true for fundamental deviation?


a) Gives location of tolerance zone
b) Capital letter is used for both holes and shafts
c) Small letter is used for both holes and shaft
d) None of the mentioned

View Answer

Answer: a
Explanation: Tolerance zone is depicted by deviation while magnitude is depicted by grade.




7 - Question

How many grades of tolerances are there according to BIS system fits and tolerances?


a) 12
b) 14
c) 16
d) 18

View Answer

Answer: d
Explanation: As per the standard.




8 - Question

Tolerance for a shaft of 50mm diameter as the basic size, with the fundamental deviation denoted by g and tolerance of grade 7 is represented as?


a) g50,7
b) 50g7
c) 7g50
d) None of the mentioned

View Answer

Answer: b
Explanation: First fundamental deviation is written followed by diameter and grade.




9 - Question

The temperature at which new stress free grains are formed in the metal is called the ______ temperature.


a) Recrystallization
b) Crystallization
c) Solidification
d) None of the mentioned

View Answer

Answer: a
Explanation: Definition of recrystallization temperature.




10 - Question

Hot working or cold working, which reduces strain hardening and residual stresses.


a) Hot working
b) Cold working
c) Both have equal effect
d) Impossible to detect

View Answer

Answer: a
Explanation: In hot working grains are re arranges as per requirement and no residual stresses.




11 - Question

Hot rolled components have better toughness and ductility.


a) True
b) False

View Answer

Answer: a
Explanation: Hot working refines grain structure an hence improves ductility and toughness.




12 - Question

Hot rolled components have better surface finish than cold rolled components.


a) True
b) False

View Answer

Answer: b
Explanation: Cold working gives better surface finish.

Get weekly updates about new MCQs and other posts by joining 18000+ community of active learners