Engineering Questions with Answers - Multiple Choice Questions

# MCQs on The Cambered Airfoil – 1

1 - Question

Is camber is the asymmetry between the two acting surfaces of an airfoil?
a) True
b) False
Explanation: Camber is the asymmetry between the two acting surfaces of an airfoil, with the top surface of a wing or corresponding the front surface of a propeller blade, commonly being more convex, positive camber.

2 - Question

Is airfoil with high camber produce the maximum lift?
a) False
b) True
Explanation: Camber is usually designed into an airfoil is to increase the maximum lift coefficient. This minimizes the stalling speed of aircraft using airfoil. Aircraft with wings based on cambered airfoils usually have low lower stalling speeds than similar aircraft with wings based on symmetric airfoils.

3 - Question

How to increase the critical angle of attack?
a) Reduce the camber
b) Increase the camber
c) Increase the thickness
d) Reduce the thickness
Explanation: An aircraft designer may also reduce the camber of the outboard section of the wings to increase the critical angle of attack at the wing tips. When the wing approaches the stall angle this will ensure that the wing root stalls before the tip, giving the aircraft resistance to spinning and maintaining ailerons effectiveness close to the stall.

4 - Question

Is supersonic flight uses supercritical airfoil?
a) True
b) False
Explanation: To do different types of maneuvers at a speed Mach greater than 1. So, the designers use negative camber airfoil this is called super critical airfoil. It is used for near supersonic flight and produces high lift to drag ratio at near supersonic flight than a traditional airfoil.

5 - Question

Is supercritical airfoil has flattened upper surface?
a) True
b) False
Explanation: Supercritical airfoil employ a flattened upper surface, highly cambered after section and greater leading edge radius as compared to traditional airfoil shapes. These changes delay the onset of the wave drag.

6 - Question

Is positive camber upper surface is more convex?
a) True
b) False
Explanation: An airfoil is said to have positive camber if, as is commonly the case, its upper surface or in the case of a propeller or turbine blade its forward surface is more convex. But camber is a complex property that can be fully characterized by an airfoil camber line.

7 - Question

What is reflexed camber airfoil?
a) Camber line curves backup near the trailing edge
b) Chord line curves backup near the trailing edge
c) Camber and chord are at stationary
d) Chord is at stationary
Explanation: An airfoil where the camber line curves back up near the trailing edge is called a reflexed camber airfoil. Such an airfoil is useful in certain situations, such as with tailless aircraft, because the moment about the aerodynamic center of the airfoil is zero.

8 - Question

Is camber is the curve of the upper and lower surfaces of an airfoil?
a) True
b) False
Explanation: The camber is the curve of the upper and lower surfaces of an airfoil. This curve is measured by how much it departs from the chord of the airfoil, the horizontal line joining the leading and trailing edges, some airfoil has a high degree of camber.

9 - Question

Is upper camber refers to the camber of the upper surface?
a) True
b) False