Engineering Questions with Answers - Multiple Choice Questions

MCQs on Satellite Applications

1 - Question

What is the primary use of communication satellites?
a) Telephone service
b) Surveillance
c) Research
d) GPS

View Answer

a
Explanation: The primary use of communication satellites is in long-distance telephone service. Satellites greatly simplify long-distance calls not only within countries but also worldwide.




2 - Question

Which of the following is not a reason for redistributing TV signals through satellites rather than skywaves or spacewaves?
a) High frequency signal
b) Long distance communication
c) Economically feasible
d) Power requirements

View Answer

d
Explanation: TV signals are being transmitted through satellites for redistribution. Because of the very high-frequency signals involved in TV transmission, other long-distance transmission methods are not technically or economically feasible.




3 - Question

What type of satellite TV service uses compressed data transmission to beam signals directly to every home?
a) Direct broadcast satellite
b) Mobile satellite service
c) Broadcasting satellite service
d) Fixed satellite service

View Answer

a
Explanation: The direct broadcast satellite (DBS) system is an all-digital system. Data compression techniques are used to reduce the data rate in order to produce high-quality picture and sound. They uses special broad coverage satellites with high power to transmit cable-TV-like services direct to homes equipped with the special DBS receivers.




4 - Question

Which frequency band does the direct broadcast satellite system use?
a) C band
b) X band
c) Ku band
d) MF band

View Answer

c
Explanation: The DBS satellite uses the Ku band with a frequency range of 11 to 14 GHz. Uplink signals are usually in the 14- to 14.5-GHz range, and the downlink usually covers the range of 10.95 to 12.75 GHz.




5 - Question

What technique does DSP use to double the number of channels by using helical antennas?
a) Spatial isolation
b) Frequency reuse
c) Multiplexing
d) Modulation

View Answer

b
Explanation: The digital signal is transmitted from the satellite to the receivers using circular polarization. The DBS satellites have right-hand and left-hand circularly polarized (RHCP and LHCP) helical antennas. By transmitting both polarities of signal, frequency reuse can be incorporated to double the channel capacity.




6 - Question

What is the number of satellites present in the Iridium system?
a) 72
b) 51
c) 66
d) 32

View Answer

c
Explanation: The satellite systems use low-earth-orbit satellites to perform the relay services to the main telephone system or to make a connection directly between any two cellular telephones using the system. One of the oldest and most widely used is the Iridium system. It uses a constellation of 66 satellites in six polar orbits with 11 satellites per orbit 420 mi above the earth.




7 - Question

Which frequency band is used for connecting the satellite system with the public switched telephone network?
a) L band
b) Ku band
c) C band
d) Ka band

View Answer

d
Explanation: The satellites communicate with ground stations called gateways that connect the system to the public switched telephone network. The satellites also communicate among themselves. Both gateway and intersatellite communication takes place over Ka band frequencies.




8 - Question

What provides the sufficient drive to the final power amplifier?
a) Intermediate-power amplifier
b) Operational amplifier
c) Power driver circuit
d) Up converter

View Answer

a
Explanation: The power amplifier usually begins with an initial stage called the intermediate-power amplifier (IPA). This provides sufficient drive to the final high-power amplifier (HPA).

Get weekly updates about new MCQs and other posts by joining 18000+ community of active learners