Engineering Questions with Answers - Multiple Choice Questions
Manufacturing Engineering – Deep Drawing
1 - Question
In which of the following process the work piece is pulled through a die resulting in reduction of area?
a) Forging
b) Drawing
c) Forming
d) Extrusion
View Answer
Explanation: Large quantities of wires, rods, tubes and other sections are produced by drawing process which is basically a cold working process. In this process, the material is pulled through a die in order to reduce it to the desired shape and size. In a typical wire drawing operation, one end of the wire is reduced and passed through the opening of the die, gripped and pulled to reduce its diameter.
2 - Question
In drawing which angle allows the introduction of lubricant into the working zone?
a) Entrance angle
b) Die angle
c) Semi-die angle
d) Relief angle
View Answer
Explanation: The entrance angle provides the entry zone to allow the introduction of lubricant into the working zone and to protect the work material against scoring by die edges. The angle is usually about 40°.
3 - Question
Degree of drawing is measured in terms of?
a) Reduction in stress
b) Reduction in force
c) Reduction in area
d) Reduction in strain
View Answer
Explanation: The degree of drawing is measured in terms of “reduction of area” which is defined as the ratio of the difference cross-sectional area before and after drawing to the initial cross-sectional area.
4 - Question
The maximum reduction in cross sectional area per pass is?
a) 45%
b) 63%
c) 55%
d) 67%
View Answer
Explanation: For perfectly plastic material, the ideal maximum reduction per pass is 63%. For a strain hardening material, the ideal maximum reduction per pass depends on the strain hardening coefficient. For example, for n = 0.19, then the maximum reduction per pass is 69.5%.
5 - Question
Which of the following die is used in drawing flat strips?
a) Square shaped
b) Rectangular shaped
c) Circular shaped
d) Wedge shaped
View Answer
Explanation: Wedge shaped die is used in drawing flat strips.
6 - Question
As the reduction increases, drawing force must be?
a) Decreases
b) Increases
c) Does not change
d) First increases and then decreases
View Answer
Explanation: With the increase in reduction the drawing force increases.
7 - Question
Which of the following angle influence the drawing force and the quality of drawn products?
a) Entrance angle
b) Die angle
c) Relief angle
d) Flake angle
View Answer
Explanation: Die angle influence the drawing force and the quality of drawn products. Die angle should be kept appropriate for better surface finish.
8 - Question
Degree of drawing is given by the expression?
a) (di-df)
b) (Ai-Af)
c) (Ai-Af)/Ai
d) 1-((df-di))
View Answer
Explanation: Degree of drawing is given by the expression(Ai-Af)/Ai. Where d is the diameter of tube.
9 - Question
If the initial diameter is 50mm2 and the final diameter after drawing is 40mm2, then the degree of drawing is?
a) .64
b) .20
c) .80
d) .36
View Answer
Explanation: Degree of drawing is given by [1- (df/di)2]. Where d is the diameter of tube.
10 - Question
If the degree of drawing is 0.5 and the initial area is 100mm2 then the final area in mm2 is equal to?
a) 50
b) 60
c) 40
d) 30
View Answer
Explanation: Degree of drawing= (Ai-Af)/Ai. Where d is the diameter of tube, A is area.